Benewake TF350 Industrial LiDAR Distance Sensor, Range: 350m - UART/CAN, IP67

The TF350 operates from a single 5V DC power supply and draws a minimum current of 180mA. Ensure your power source can provide stable 5V power with sufficient current headroom for reliable operation, especially at higher measurement frequencies.

The TF350 provides two industrial communication interfaces: UART (serial) and CAN bus. You can select the appropriate interface via configuration. The UART interface uses standard TTL logic levels for direct connection to microcontrollers, while the CAN interface is suitable for integration into vehicle or industrial networks.

Accuracy is ±10cm for targets within 10 meters and 1% of the measured distance beyond 10 meters. The maximum achievable range is highly dependent on target reflectivity. A high-reflectivity (90%) target can be detected up to 350m, while a low-reflectivity (10%) target reduces the maximum range to approximately 150m under normal light conditions.

Yes, the TF350 is designed for outdoor use. It incorporates compensation algorithms to counteract interference from ambient light up to 100,000 lux. Under such intense light, the maximum range is reduced; for example, a 90% reflective target can be detected up to 300m instead of 350m.

The default operating frequency is 100 Hz, meaning it takes 100 distance measurements per second. This rate is fully configurable via its communication interfaces, allowing users to adjust it from 1 Hz up to 1000 Hz to balance measurement speed, power consumption, and data processing requirements for specific applications.