EKA Castable Resin for Jewelry, Mango Yellow (250g)

EKA Castable Resin is fully compatible with both DLP and LCD 3D printers. It supports a broad range of curing wavelengths, specifically optimized for machines operating at 385nm and 405nm. This ensures versatility across various professional jewelry manufacturing setups and consistent, high-detail print quality.

For optimal, clean burnout in lost wax casting, follow a carefully controlled ramp and soak firing schedule. Ensure sufficient oxygen flow in your burnout oven and avoid excessively rapid temperature changes. The resin is formulated to minimize ash and residue when proper protocols are observed.

While not always strictly necessary, preheating the EKA Castable Resin to around 37°C is highly recommended, especially if your 3D printer's resin vat lacks a built-in heater. This helps reduce viscosity, improves flow, and promotes better print consistency and detail resolution, particularly for intricate jewelry models.

EKA Castable Resin boasts an ultra-low volumetric shrinkage rate of approximately 3%. This minimal shrinkage is crucial for maintaining high dimensional accuracy, which is paramount for intricate jewelry designs where precise measurements and tight tolerances are required for successful casting and stone setting.