Banner Engineering PIT46U-VL Plastic Fiber Optic Cable, Opposed Mode, 1mm Core, 2m Length

The PIT46U-VL is configured for opposed-mode (also known as through-beam) sensing. This requires the cable to be used with a compatible fiber optic sensor system where the transmitter and receiver are separate units. The cable carries light from the transmitter to one side of the detection point and from the detection point back to the receiver, allowing an object to be detected when it breaks the light beam.

This cable features an M4 threaded end for secure mounting into the sensor housing or mounting bracket. The sensing tip at the opposite end has an M2.6 thread, allowing for the attachment of lenses or mounting in a fixed fixture. Ensure threads are clean and use appropriate torque to avoid damaging the plastic fiber during installation.

The cable is rated for continuous operation in environments up to 70°C. The minimum bend radius is 25mm to prevent damage to the internal plastic fiber and ensure optimal light transmission. The cable is also rated for a minimum of 1000 repeat bending cycles at this radius, making it suitable for applications with occasional flexing.

This cable is designed for use with compatible Banner Engineering fiber optic sensor amplifiers, such as the DF-G series. The maximum achievable sensing distance depends on the amplifier: 558 mm with DF-G1, 904 mm with DF-G2, and 4335 mm with DF-G3 models. Always consult the specific amplifier's manual for correct configuration and performance verification.