ReadyToSky NEO-M8N GPS Module w/ Compass for APM/Pixhawk
This ReadyToSky NEO-M8N GPS module integrates a high-precision u-blox M8 engine with an onboard compass, offering rapid 10Hz position updates and robust multi-GNSS support. Engineered for seamless compatibility, it includes connectors for both APM and Pixhawk flight controllers, providing reliable navigation for diverse UAV platforms.
Features
- High-precision u-blox NEO-M8N 72-channel GNSS receiver.
- Integrated onboard compass for accurate heading data.
- Supports GPS/QZSS, GLONASS, and Galileo-ready for superior satellite coverage.
- Fast 10Hz navigation update rate with 2.0m CEP position accuracy.
- Pre-configured with connectors for direct APM and Pixhawk flight controller integration.
Out of stock
This NEO-M8N module offers exceptional sensitivity, incorporating active circuitry for its ceramic patch antenna and housed within a protective plastic case to withstand environmental elements. It delivers precise position updates at 10Hz and includes a rechargeable backup battery, facilitating quick warm starts. This module is configured at a 38400 baud rate, ensuring seamless integration with Pixhawk and APM flight controllers, though cable modification may be required for specific autopilot boards.
Representing a new generation of GPS technology, the NEO-M8N module boasts low power consumption and high precision, achieving an ultimate accuracy of approximately 0.9 meters, a significant improvement over the 1.4-1.6 meters of previous generations like the NEO-7N. It supports multi-GNSS modes including GPS/QZSS L1 C/A and GLONASS L10F. The combination of the NEO-M8N chip and ceramic antenna ensures rapid satellite locks and stable signal acquisition, complemented by a sturdy stand designed to mitigate electromagnetic interference.
This module comes pre-connected with a 5-pin connector for APM flight controllers and includes an extra 6-pin connector for Pixhawk, allowing for flexible integration. While the genuine u-blox chip permits configuration via U-Center, note that firmware updates to V3.01 are not supported due to the specific module’s flash memory size.
Additional Information
| Dimensions | 5.4 × 5.4 cm |
|---|
