Pro-Range Standard Water Washable Resin Red Wax 1Kg

After printing, remove the model and rinse thoroughly with clean tap water for 1-2 minutes, using a soft brush if necessary to remove uncured resin from crevices. Ensure all residue is gone, then air dry or use a gentle fan before proceeding to post-curing for best results.

For optimal mechanical properties, post-cure models under a 395-405 nm UV light source. Curing times typically range from 2-5 minutes per side, depending on the intensity of your UV lamp and part thickness. Ensure all surfaces are exposed uniformly.

While this resin provides good mechanical strength and impact resistance, prolonged outdoor exposure to UV light and harsh weather is generally not recommended for standard resins. For outdoor applications, a specialized UV-resistant engineering resin would be more suitable to prevent degradation over time.

Start with an exposure time of 2-3 seconds per layer for monochrome LCD printers or 8-12 seconds for RGB screens, adjusting based on your printer's wattage and specific model. Ensure your build plate is level and the room temperature is stable, ideally between 20-25°C, to prevent printing failures.