Moresense MS58-2020D13M4 UART Tool - Ultrasonic Sensor Interface Module

This module is a dedicated UART interface and signal conditioning tool for Moresense MS58 series ultrasonic sensors. It converts the sensor's raw signal into a UART serial data stream and provides a configurable digital I/O output, simplifying integration with microcontrollers, PLCs, and data acquisition systems.

UART parameters are configured by placing two Jumper caps onto the specific pin headers marked with blue arrows on the testing board. The exact UART settings (baud rate, data bits, parity) are typically defined by the sensor's datasheet and the Jumper configuration, which should be cross-referenced for proper setup.

The DIP switch, located in the green marked area, allows you to select from four pre-defined distance detection thresholds. This converts the analog ranging data into a digital on/off signal, useful for simple proximity alerts. The left switch position corresponds to a logic '0' (no detection) and the right to a logic '1' (detection) for the selected threshold.

The module accepts a wide DC input voltage range from 5V to 12V, making it compatible with common power supplies in embedded systems (e.g., 5V USB, 12V adapters). The integrated power switch allows you to cycle power without disconnecting the supply. Ensure your power source can provide the typical 62mA operating current.