Sencoch GZP160-010DR Pressure Sensor, -10Kpa~10Kpa Range, Analog Voltage Output, DIP-6 Package

The GZP160-010DR provides an analog voltage output. The output voltage varies ratiometrically with the applied pressure within the ±10 kPa range, making it directly compatible with the ADC inputs of microcontrollers like Arduino or ESP32 for digital conversion and processing.

The sensor operates from a 5V to 15V DC power supply. It is recommended to use a stable, low-noise voltage source within this range to ensure accurate analog output readings. The sensor's performance is typically specified at a nominal voltage like 5V or 10V.

Yes, as a gauge pressure sensor with a ±10 kPa range, the GZP160-010DR can measure both positive pressure (above atmospheric) and negative pressure (vacuum or below atmospheric). The analog output will correspond to the pressure differential relative to ambient atmosphere.

Connect the sensor's V+ pin to a 5V supply on the Arduino, GND to ground, and the analog output pin to one of the Arduino's analog input pins (e.g., A0). Use the Arduino's ADC to read the voltage. You will need to map the voltage reading to the pressure value using the sensor's transfer function, typically found in its datasheet.