LoRa Antenna 915MHz 2.2dBi RP-SMA Omnidirectional

This antenna uses an RP-SMA male connector. To connect it to a standard SMA female port, you will need an RP-SMA female to SMA male adapter. Always verify the polarity of your device's connector, as mismatched SMA/RP-SMA connections can cause poor electrical contact and signal loss. Ensure the adapter is rated for 50-ohm impedance and frequencies up to 1 GHz for optimal LoRa performance.

Range improvement depends on your transmitter power, receiver sensitivity, and environment. A 2.2dBi gain provides a modest boost in effective radiated power (ERP) compared to a 0dBi reference. In open areas with a 20dBm LoRa module, you might see a 10-20% increase in reliable communication distance. For maximum range, ensure a clear line of sight, minimal VSWR by using a quality cable, and orient the antenna vertically for proper polarization matching with other nodes.

Yes, the antenna is fully weatherized and rated for an operating temperature range of -20°C to +85°C, making it suitable for permanent outdoor installation. For best longevity, ensure the RP-SMA connection is properly sealed against moisture ingress using a waterproof tape or silicone sealant. The flexible shaft is resistant to wind and vibration, but avoid placing it under constant mechanical stress or in direct paths where it could be physically damaged.