ELEGOO Standard Photopolymer Resin - Red (1000g)

Store resin in its original sealed bottle, away from direct sunlight and UV light, at room temperature (15-35°C). Ensure the cap is tightly secured after each use to prevent contamination and premature curing, which helps maintain its properties for consistent printing results.

For optimal adhesion, ensure your build plate is clean and properly leveled. A light sanding with fine-grit sandpaper can improve surface texture. Pre-heating the resin vat slightly to 25-30°C can also enhance initial layer adhesion, especially in cooler environments, preventing print failures.

After printing, thoroughly wash models with IPA (isopropyl alcohol) and dry completely. Post-cure using a 405nm UV curing station or direct sunlight. Typical curing times range from 2-10 minutes depending on part thickness and UV intensity, enhancing final hardness and mechanical strength.

While possible, mixing resins is generally not recommended unless specified by the manufacturer. Different resin formulations can have varying properties, pigments, and photoinitiators, which may lead to unpredictable curing behavior, compromised mechanical properties, or color inconsistencies in your prints.