Generic K-Type Surface Thermocouple Probe - 0 to 600°C Range, 3M Cable

This probe generates a passive millivolt signal. You must connect it to a device with a dedicated K-type thermocouple input, such as a temperature transmitter, data logger, PLC analog input module configured for thermocouples, or a standalone thermocouple-to-digital converter. Standard voltage inputs cannot directly interpret the signal without proper cold-junction compensation.

The cable is designed with high-temperature insulation suitable for environments near the probe. However, for extended runs in extremely hot ambient air, consult the specific insulation rating. It is generally recommended to route the cable away from direct heat sources when possible to ensure long-term reliability.

For best accuracy, ensure full, flat contact between the probe tip and the measured surface. Use thermal paste or a mechanical clamp to improve thermal conductivity and minimize air gaps. The reading reflects the temperature at the point of contact, so placement is critical for representative measurements of the target surface.