Multistar Elite 2204-2300KV Multi-Rotor Motor - CCW

This motor is optimized for 3S to 4S LiPo battery systems (approximately 11.1V to 14.8V nominal). Exceeding the 4S (15V maximum) rating can lead to excessive heat, demagnetization, and premature failure. Always ensure your Electronic Speed Controller (ESC) is rated for the same voltage and current.

No, it is not recommended. The motor is specifically tuned and rated for 5-inch propellers on 3S-4S power. Using larger props significantly increases the load, causing the motor to draw more current than its 25A continuous rating, leading to overheating and potential ESC or motor failure.

The shaft is designed to be removable. You will need a gear puller or a small bearing press to carefully extract the damaged shaft from the bell housing. Install the replacement shaft by pressing it in until it seats fully, ensuring the knurled section engages properly. Avoid hammering, as this can damage the bearings.

This specific SKU is a Counter-Clockwise (CCW) rotation motor. For a standard quadcopter 'props-out' configuration, you would need two CCW and two CW motors. Always pair motors with the correct rotation to ensure proper flight dynamics and propeller tightening direction.