Numakers Stone PLA Filament 1.75mm 1kg

The manufacturer suggests a broad range of 200-300°C for the nozzle and 30-60°C for the print bed. For best results with aesthetic finishes, start around 200-210°C, then adjust. The slightly higher range might accommodate the composite stone particles, but always verify with test prints for your specific setup.

Yes, it is recommended to use a nozzle size of 0.6mm or larger. This helps prevent clogging due to the stone-like particles embedded in the filament. Smaller nozzles can be prone to blockages, affecting print quality and reliability. Using a larger nozzle ensures smoother extrusion.

Numakers Stone PLA features excellent bed adhesion. Ensure your print bed is clean and level. A bed temperature between 30-60°C is recommended. For stubborn cases, consider a thin layer of PVA glue stick or a dedicated adhesive spray. Printing with a brim or raft can also enhance initial layer adhesion.

Like most PLA filaments, Stone PLA benefits from dry storage. Keep the spool sealed in its original vacuum bag with desiccant when not in use. This prevents moisture absorption, which can lead to brittle filament, poor layer adhesion, and bubbling during printing, compromising the unique stone finish.