eSUN PW100 PLA Water Washable Resin, Beige 1kg

Recommended exposure times typically range from 2-4 seconds for mono LCD screens and 6-10 seconds for RGB screens, depending on your printer and layer height. A build plate temperature of 25-30°C can improve adhesion. Always perform calibration prints, like an R_E_R_F test, to fine-tune settings for optimal results and detail reproduction.

After printing, rinse parts thoroughly with tap water to remove uncured resin. Use a soft brush for intricate details. Once clean, dry the parts completely, then post-cure them under a 395-405nm UV light for 2-5 minutes per side, ensuring full polymerization and maximum mechanical properties.

The primary advantage is simplified cleanup, eliminating hazardous chemical solvents like IPA, making post-processing safer and more environmentally friendly. The bio-based PLA polyol component further reduces the ecological impact. It also offers a low odor profile, improving the overall printing experience in home or office settings.

While eSUN PW100 PLA Water Washable Resin has a low odor, a well-ventilated area is always recommended for resin printing. An enclosure is not strictly necessary for odor control but can help maintain a stable printing temperature, which benefits print consistency and success, especially in cooler environments, preventing warping.

Store the resin in its original opaque bottle, tightly sealed, in a cool, dry, and dark place away from direct sunlight and UV light sources. Ensure the temperature remains between 15-30°C. Proper storage extends the shelf life and prevents premature curing or degradation of the resin's properties for future use.