eSUN Water Washable Resin - Transparent Green 0.5kg

Store the resin away from direct light, ideally in a cool, dark place with stable humidity, and keep the bottle tightly sealed. During printing, ensure your resin printer's lid is closed to minimize indoor light exposure and pour only the amount needed for the current print job to maintain resin quality.

After printing, clean the model thoroughly with water to remove uncured resin. For optimal results, follow with 1-2 minutes of UV lamp post-curing to fully harden the part and prevent humidity effects. Store any unused cleaned resin in a separate, sealed bottle, not back into the original container.

Excessive UV exposure during post-curing can cause yellowing. To mitigate this, ensure post-curing times are within the recommended range. If a print has already yellowed, you can try soaking it in hot water and briefly microwaving for about 30 seconds; this often helps reduce the yellow tint.

For optimal transparency, start post-processing by wet-sanding from lower-mesh sandpaper (e.g., 400 grit) to progressively higher meshes (e.g., 800 grit or finer). After achieving a smooth polish, apply an anti-UV high-translucency clear coat. This multi-step approach will significantly enhance clarity and surface quality.